Delta Electronics ASDA-B Series User Manual

Chapter 7 Servo Parameters|ASDA-B Series
Revision January, 2009 7-17
Others
Control
Mode
Parameter Name Function Default Unit
P S T
P1-32 LSTP Motor Stop Mode Selection 0 N/A
{ { {
P1-37 GDR
Ratio of Load Inertia to Servo Motor
Inertia
10
0.1
times
{ { {
P1-52 RES1 Regenerative Resistor Value 40 Ohm
{ { {
P1-53 RES2 Regenerative Resistor Capacity 60 Watt
{ { {
P2-08■
PCTL
Special Factory Setting
0 N/A
{ { {
P2-30■
INH
Auxiliary Function
0 N/A
{ { {
P2-34 SDEV Overspeed Warning Condition 5000 rpm
{
P2-35 PDEV Excessive Error Warning Condition 3000 10pls
{
P2-36 OVL Overload Protection Level 100 %
{ { {
P2-37 OVW Output Overload Warning Level 50% N/A
{ { {
P2-38 GBIT Special Function 0 N/A
{ { {
Explanation of symbols (marked after parameter)
(★) Read-only register.
(▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
(●) Parameter is effective only after the servo drive is restarted (after switching power off and on).
(■) Parameter setting values are not retained when power is off.

Delta Electronics ASDA-B Series Specifications

General

Brand	Delta Electronics
Model	ASDA-B Series
Category	DC Drives
Language	English