Delta AH500 - Page 328

AH500 Programming Manual
6-160
X0.0
Y0.0
Y0
.1
Y0.2
Y0.3
5 seconds
5 seconds
5 seconds 5 seconds
5 seconds
5 seconds
5 seconds
5 seconds
6. When the conditional contact X0.0 is followed by the normally-closed contact Y0.0, the flashing
currents pass through Y0.1 and Y0.2. When X0.0 is switched OFF, Y0.0, Y0.1, and Y0.3 are
switched OFF, and T0 is reset to 0.
X0.0
Y0.1
Y0.2
5 seconds
5 seconds
Additional remark:
1. If D+3 exceeds the device range, the instruction is not executed, SM0 is ON, and the error
code in SR0 is 16#2003.
2. If m is less than 0, the instruction is not executed, SM0 is ON, and the error code in SR0 is
16#200B.
3. If users declare the operand D in ISPSoft, the data type will be ARRAY [4] of BOOL.