AH500 Programming Manual
6-180
The experimental result of using the parameters which have been tuned to control the
temperature is shown below.
As the diagam above shows, after the parameters are tuned automatically, users can get a good
temperature control result. It only takes about twenty minutes to control the temperature. When the
target temperature changes from 80°C to 100°C, the result is as below.
As the diagam above shows, when the target temperature changes from 80°C to 100°C, the
parameters tuned previously still can be used to control the temperature. Besides, it does not take
much time to control the temperature.
To Next Page
Loading...
