Delta M50A-260 - Writing and Labeling Conventions

1.4 Writing and labeling conventions
Some sections in this manual are specially labeled.
Labeling of work instructions
Work instructions that must be performed in a specic sequence
are numbered accordingly. Numbered work instructions must
always be performed in the specied sequence.
1. First step
→ Where necessary, the result of the work step is de-
scribed here. This is used for checking that the work
step has been completed correctly.
2. Second step
3. Third step
þ
Work step is now complete.
If the work instructions consist of just one single step or the work
steps can be performed in any desired sequence then the work
steps are labeled as follows:
► Step
► Step
Labeling of inverter components
LEDs  LED
LED Meaning
LED stays on.
LED ashes.
LED is o󰀨.
9
Installation and Operation Manual M50A_260 RPI503M260000 Product version L and M EU V1.3 EN 2023-08-14
1 About this manual
Target audience of this manual