1
Either turn <SOURCE SELECT> or press [TUNER] to
select “TUNER”.
2
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “TUNER”.
(vpage 38 “Remote Control Unit Operations”)
3
Press <RDS> until “RDS Search” appears on the
display.
4
Press <PRESET CHANNEL> or [CHANNEL + –].
The search for RDS stations begins automatically.
b If no RDS stations are found with the above operation, all the
reception bands are searched.
b When a broadcast station is found, that station’s name appears on
the display.
5
To continue searching, repeat steps 3 and 4.
b If no RDS station is found when all the frequencies have been
searched, “NO RDS” is displayed.
RDS Search
Use this function to automatically tune to FM stations that provide
the RDS service.
4
Watching the display, press ui to call out the desired
program type.
5
Press <PRESET CHANNEL> or [CHANNEL + –].
PTY search begins automatically.
b If there is no station broadcasting the designated program type
with the above operation, all the reception bands are searched.
b The station name is displayed on the display after searching
stops.
6
To continue searching, repeat steps 3 and 5.
b If no station broadcasting the designated program type is found
when all the frequencies have been searched, “NO PROGRAMME”
is displayed.
PTY Search
Use this function to find RDS stations broadcasting a designated
program type (PTY).
For a description of each program type, refer to “Program Type
(PTY)”.
Getting Started Connections Setup Playback Remote Control Information Troubleshooting
ENGLISH
Specifications
1
Either turn <SOURCE SELECT> or press [TUNER] to
select “TUNER”.
2
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “TUNER”.
(vpage 38 “Remote Control Unit Operations”)
3
Press <RDS> until “TP Search” appears on the
display.
4
Press <PRESET CHANNEL> or [CHANNEL + –].
TP search begins automatically.
b If no TP station is found with the above operation, all the reception
bands are searched.
b The station name is displayed on the display after searching
stops.
5
To continue searching, repeat steps 3 and 4.
b If no other TP station is found when all the frequencies have been
searched, “NO PROGRAMME” is displayed.
TP Search
Use this function to find RDS stations broadcasting traffic
programs (TP stations).
1
Either turn <SOURCE SELECT> or press [TUNER] to
select “TUNER”.
2
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “TUNER”.
(vpage 38 “Remote Control Unit Operations”)
3
Press <RDS> until “RT” appears on the display.
4
Press o p to set.
b When the Radio Text (RT) display is set to “ON”:
While receiving an RDS broadcast station, the text data broadcast
from the station is displayed.
b When the Radio Text (RT) display is set to “ON”:
If no text data is being broadcast, “NO TEXT DATA” is displayed.
b To turn off the radio text display, press <RDS> when radio text is
displayed.
RT (Radio Text)
Turn the Radio Text (RT) display ON/OFF.
1
Either turn <SOURCE SELECT> or press [TUNER] to
select “TUNER”.
2
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “TUNER”.
(vpage 38 “Remote Control Unit Operations”)
3
Press <RDS> until “PTY Search” appears on the
display.
To Next Page
Loading...
Need help?
General
