Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsPlayback
Other Operations and Convenient Functions
DENON LINK 4th uses the clock of the AV amplifier connected by
DENON LINK to achieve HDMI signal transfer with little jitter when
playing BD.
NOTE
Set the Blu-ray disc player’s “HDMI Control” setting to “ON”, the
“DENON LINK” setting to “4th”. For instructions on operation, refer
to the Blu-ray disc player’s manual.
The jitter-free function does not work except during BD playback. In
this case, the video signal is output from the HDMI OUT terminal,
and the audio signal from the DENON LINK terminal.
When a BD is played with the input mode set to “Auto”, playback
is performed in the DENON LINK 4th mode. When a disc other
than a BD is played with the input mode set to “Auto”, playback is
automatically performed in the DENON LINK 3rd mode.
When the input mode is set to “HDMI”, normal HDMI playback is
performed.
When the input mode is set to “Digital”, playback is fixed to the
DENON LINK 3rd mode and BDs cannot be played.
•
•
•
•
•
1
Assign “HDMI” to the input source to be used, and
assign “D.LINK” to the “Digital” setting (vpage
59 “Input Assign”).
2
Set “HDMI Control” – “Control” (vpage 44) to
“ON”.
3
Either turn <SOURCE SELECT> or press [INPUT
SOURCE SELECT] to select the input source assigned
in step 1.
The “ ” indicator lights on the display.
4
Set “Input Mode” (vpage 61) to “AUTO”.
5
Select the surround mode (vpage 87 “Selecting the
Surround Mode (Surround Mode)”).
6
Start playing the BD.
Playback starts.
Other Operations
Playing a Blu-ray Disc Player Compatible
with DENON LINK 4th
To play DENON LINK 4th signals, make HDMI and DENON LINK
connections with the compatible Blu-ray disc player.
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
[INPUT
SOURCE
SELECT]
[ MAIN]
To Next Page
Loading...
