Denon AVR-4810CI - Speaker Connections


Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsConnections
Speaker Connections
The AVR-4810CI can be connected to a maximum of three subwoofers.
The same signal is output from each subwoofer terminal.
w q
w q
w q w q
*/
w q
(R)
(L) (R)
*/ */
(L)
C A B
Subwoofer
(1st unit)
Center
speaker
Front
speakers
Surround
speakers
Subwoofer
with built-in
amplifier
For the
A B C
speaker terminals, the output channels are different depending on the “Amp Assign” setting. Set
“Amp Assign” to suit the speaker system being used and connect the speakers referring to the following chart.
(2nd unit) (3rd unit)
A
: S.BACK/F.HEIGHT/F.WIDE and F.HEIGHT/
F.WIDE speaker terminals
Use when connecting surround back speakers, front height speakers
or front wide spekars.
Speaker connections
w q w q
(L) (R)
w q w q
(L) (R)
Surround back speakers,
Front height speakers
or Front wide speakers
Front height speakers or
Front wide speakers
Relationship between “Amp Assign” settings and channels
output by each speaker terminal
“Amp Assign”
setting
(vpage 39 ~ 41)
Channels output by each speaker
terminal
Config.
Extra
Channel
S.BACK/
F.HEIGHT/
F.WIDE
F.HEIGHT/
F.WIDE
11.1ch
(
b
)
SB/FH/FW S.BACK F.HEIGHT
9.1ch SB/FW S.BACK F.WIDE
SB/FH S.BACK F.HEIGHT
FH/FW F.HEIGHT F.WIDE
7.1ch SB S.BACK –
FH F.HEIGHT –
FW F.WIDE –
5.1ch – – –
b : Use the PRE OUT terminal for the front wide channel output.
n
n