Denon AVR-4810CI - Control Unit··········································································108; Operating the Connected Devices by Remote Control Unit; Operating the Main Remote Control Unit; Operating AV Equipment

0
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsRemote Control
Operating the Connected Devices by Remote Control Unit
Operating the Main Remote
Control Unit
On the main remote control unit, the display switches according to
the device being operated and the mode.
In the “MAIN”, “TUNER”, “SAT TU”, “DTU”, “iPod” and “NET/USB”
modes, when the remote ID is set, the AVR-4810CI can be used
independently even in an environment containing multiple DENON
amplifiers. (vpage 112 “Setting the Remote ID”)
•
•
Operating AV Equipment
1
Press [DEVICE SELECTOR] for the component to be
operated.
The indicator for the component to be operated flashes.
: MAIN / ZONE2 / ZONE3 / ZONE4 / MACRO
: TUNER (FM/AM).
: XM / SIRIUS
: HD Radio (Digital Tuner)
: Satellite Receiver / Cable Tuner / IPTV / HDTV (Set Top
Box )
: iPod
: Network / USB
:
Blu-ray Disc Player / HD DVD Player /
DVD Player (Recorder) / CD Player (Recorder)
:
Digital Video Recorder
: TV
[MUTE]
[0 ~ 9]
[POWER ON]
[ DVD/HDP]
[ SAT/CBL]
[ VCR/DVR]
[ TV]
[DEVICE
SELECTOR]
[POWER OFF]
[RC SETUP]
[MASTER
VOLUME]
[QUICK
SELECT]
[ MAIN]
Signal
transmission
indicator
In ZONE2, ZONE3 and ZONE4 modes, you can switch the MAIN
ZONE power on or off by pressing [POWER ON] or [POWER OFF].
[QUICK SELECT], [MUTE] and [MASTER VOLUME] can also be
operated when the device selected is something other than [MAIN].
In this case, the zone you used last can be operated. Check using
the zone indicator.
•
•
The mode switches each time [MAIN] is pressed.b
G
MAIN modeH GZONE2 modeH GZONE3 modeH
GMACRO modeH GZONE4 modeH
2
Operate the component.
For details, refer to the component’s operating instructions. b
Multi-zone