Denon AVR-4810CI - Page 77


Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsPlayback
Tuning in Radio Stations – SIRIUS Satellite Radio
“UPDATING” is displayed while the encording code is being
updated.
“SIRIUS UPDATING” is displayed when updating SIRIUS tuner
firmware.
Refer to “Troubleshooting” – “SIRIUS Satellite Radio” (vpage
133) regarding other messages.
•
•
•
1
Tune to the channel you want to lock.
2
Press ENTER for at least 3 seconds.
“Enter Lock Code” is displayed.
3
Enter the 4-digit lock code using uio p.
When you enter the correct code, the corresponding channel
is locked.
4
Press ENTER.
1
Press [SEARCH].
2
Press [0 ~ 9] to input the channel.
Example: Accessing channel “SR123”: Press [1], [2] and [3].
If no button is pressed within several seconds, the channel
automatically switches to the one whose number has been input.
b
3
Press ENTER to set that channel.
Reception switches to the selected channel.
Channels under Parental Lock cannot be tuned in by performing
Tuning Up/Down or by category search.
Channels stored in preset memory can be tuned in by the preset
channel select operation, even if Parental Lock is applied.
When a channel to which Parental Lock is applied is being played,
Parental Lock for that channel is cancelled by performing step 2.
See “Edit Lock Cord” (vpage 65) for the method of changing
Parental Lock Cord.
You can also set “Parental Lock” (vpage 65) from the menu.
•
•
•
•
•
Accessing SIRIUS Satellite Radio Channels Directly
Parental Lock
1
Press o p.
S R 0 0 1 H i t s 1
C A T : P o p s
2
Use o p to select the category, to use ui to select
the desired channel.
Channel category
Searching Categories
Button located on both the main unit
and the remote control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
<SOURCE SELECT>
<TUNING PRESET>
ENTER
uio p
ENTER
[SEARCH]
[0 ~ 9]
[ SAT TU]
uio p
[SEARCH]
[CHANNEL]
[A ~ G]
[DTU]
[MEMO]
[MODE]
[BAND]
[TUd]
[TU f]
[ DTU]
uio p
[0 ~ 9]
[SOURCE
SELECT]
ENTER
(MAIN mode)
(MAIN mode)
[SHIFT]
[DTU]
[SAT TU]
Sub remote control unit