EN-34 Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
3.11.4 Rims
Wear
WARNING
Look out for deep grooves on both rims.
The rims could fracture and cause a fall.
Replace rims as soon as you detect signs
of wear. Many rims have a wear indica-
tor. If it can no longer be felt at a certain
point, the rim is worn.
Wear indicator
Cleaning
1. Remove the pedelec battery.
2. Brush the rims with a hand brush. Heavier soiling can be removed with
a soft, damp cloth.
IMPORTANT
When you are cleaning the rims, make sure that no water gets into the
motor. Water ingress can damage the motor.
3. Leave to dry.
Quick-release skewer is too easy to
close
1. Open the quick-release skewer.
2.
Hook the quick-release lever into the slot
and turn it clockwise. This will screw the
axle in the thread. Make sure that your
wheel is correctly centred.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
Quick-release skewer is not easy to
close
1. Open the quick-release skewer.
2.
Hook the quick-release lever into the slot
and turn it anticlockwise until the quick-
release axle protrudes from the axle hole
about 1 cm.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
WARNING
Reattach any previously disconnected cables (e.g. lighting cables ),
otherwise you could tear them.
To Next Page
Loading...
