Derby cycle Impulse Evo - Changing Ride Profile; Switching off the Pedelec

Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4 EN-43
5.9 Changingrideprole
1. While in the start menu, press the button for three seconds. You are
now in the main menu.
2. Select main menu option “Settings” using the
/
buttons. The option
selected is highlighted.
3. Conrmbybrieypressingthe
button. You are now in sub-level 1.
4. Select “Device settings” using the
/
buttons.
5. Conrmwith
6. Select “Drive” using the
/
buttons. The option selected is
highlighted.
7. Conrmbypressingthe
button. You are now in sub-level 2.
8. Select“Bikingprole”usingthe
/
buttons. The option selected is
highlighted.
9. Conrmbypressingthe
button.Youaccesstherideproles.
Ride
prole
Characteristics
Power on
start-up
Power
delivery
Maximum
power
Power
consumption
Relax
Low Low Low Low
Regular
Medium Medium Medium Medium
Dynamic
High High High High
10. Use the
/
buttons to select the required option.
It is highlighted.
11. Brieypressingthe
button returns you to sub-level 2.
5.10 Switchingothepedelec
DANGER
Only ride the pedelec when you can safely reach the brakes  3.7
Braking Page EN-22. Your pedelec does not have an Emergency stop
button. You must activate the brakes to stop the cycle quickly in a
dangerous situation. The maximum brake force is greater than the
propulsion force possible. This means stopping is guaranteed at all
times by pressing the brakes. Note that the drive system does not
disable automatically after braking. Switch the drive system to idle
after braking.
On the easy-reach control
1. Press the
button on the easy-reach control for one second. The
ImpulseEvosystemswitcheso.
Via the battery
1. Brieypressthebatterybuttontwice.TheImpulseEvosystem
switchesoafterafewseconds.