Derby cycle Impulse Evo - Technical Details

EN-92 Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
10.2 Technical details
Charger type 1
Battery voltage
36 V
AC input voltage
230- 240 V
Frequency
50 - 60 Hz
Max. DC output voltage
42 V
Max. charge current
4 A
Dimensions ( L | W | H )
175mm|82mm|47mm
Permitted ambient temperature
range during charging
0to+40˚C
Storage temperature
-10to+50˚C
Recommended storage
temperature
18to23˚C
Weight
720g
Protection class
The charger is only intended to be used
indoors. Keep the charger away from rain
and moisture. Water penetrating into the
charger poses a risk of electric shock.
Charger cable
Power cable
WARNING
Keepbatterychargersawayfromsparksandres. It can explode
causingsevereburnsandres.Furtherconsequencescaninclude
malfunctions and a reduced service life. Ensure there is adequate
ventilation for charging.
IMPORTANT
The mains voltage must match the supply voltage of the battery
charger, otherwise there is a risk of damage to the device. The supply
voltageforthechargerisspeciedonthelabelonthebackofthe
device.
Do not charge batteries for a long period if they are already fully
charged or are not being used. Electricalstorms,voltageuctuations
and short circuits can damage the battery.
Keep the battery charger clean. If the contacts are dirty, the dirt can
burn during charging, leaving burn marks. The charger may need to be
replaced in such cases  10.4.1 Cleaning Page EN-95.