Derby cycle Impulse Evo - Page 201

EN-94 Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
If the battery now stays on the charger, the charger
regularly checks whether the battery is still fully charged.
ThechargerLEDstartstoashagain.Aftercheckingand
ascertaining that the battery is full, the charger switches
back to “light continually”.
6. Remove the power cable from the socket after completing the charging
process.
7. Remove the charging cable from the battery charging socket.
8. Fold down the protective battery cap.
10.3.1.1 Battery display during charging
Display Description Battery charge level

5LEDslightupandnoLEDashes 100–97%


4LEDslightupandthe5thLEDashes 80 – 96%


3LEDslightupandthe4thLEDashes 60–79%


2LEDslightupandthe3rdLEDashes 40 – 59%


1LEDlightsupandthe2ndLEDashes 20 – 39%

1LEDashes 0 – 19%
4. AllveLEDs light continually on the battery when it is fully
charged.NoLEDashes.
5. Remove the power cable from the socket after completing the charging
process.
6. Remove the charging cable from the battery charging socket.
Charging the battery with charger type 2
1. Connect the power cable to the battery charger.
2. Fold up the protective cap on the battery.
3. Connect the charging cable to the battery charging socket (it clicks into
place).
4. Insert the mains plug into a power socket. The red LED lights red
briey,thenthegreenLEDashesataconstantspeed
.
5. Thechargerswitchesooncethebatteryisfullycharged.Thegreen
LED on the charger is continually on
.AllveLEDs on the
batterylightcontinually.NoLEDashes.