KRYPTON®
TECHNICAL REFERENCE MANUAL
If the driver is not installed, it can be downloaded from our web page .
● If the driver is already installed and the devices are still not recognized, the Speed & Duplex of the
network card needs to be adjusted manually.
○ Go to network connections
○ Right-click on the connection where the EtherCAT devices are connected
○ Go to configure, advanced options, find Speed & Duplex, change the value to 100 Mbps
Full Duplex
● In case Windows 7 is used, it needs to be updated to Service pack 1 which accepts the 256-bit
certificates. You can find the proper update versions on the Microsoft web page , for both the
32-bit and 64-bit versions.
KRYPTON® V20-1 20 / 141
To Next Page
Loading...