DHD Series 52 - 10.1.4.1 Configuration

© 2013 DHD Deubner Hoffmann Digital GmbH
32
Series 52 - 52/DX Compact Mixing Console Manual
Specifications and design are subject to change without notice. The content of this document is for information only. The information presented in this document does not form part
of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use.
Publication thereof does neither convey nor imply any license under patent rights or other industrial or intellectual property rights.
10.1.3.2 Load from Device
This command loads a Config from a device to the DXConfig software. In the
DHD Connection Dialog
window you
must select the corresponding device. (See figure DHD Connection Dialog window for connections with the device)
Note
If the device you are downloading a Config from is already included in the
project, it is automatically selected in the
DHD Connection Dialog
. This
requires identical values for project ID and device ID both in the project and the
device itself.
Alternatively, you can create an new device. Then, load the Config into this empty device.
Warning
Be aware that changes of device caused by downloads can not be undone, as
soon as the device file is saved. Therefore, for safety reasons, always work with
copies of the original device files.
In general, it is always better to save the current Config of a device as device file. If other changes become necessary,
load the device file again and modify it. After that, load the new Config to the corresponding devices. This way, the device
file is always up to date and is available as a backup for the configuration data in the devices at the same time.
You can execute the command
Load from Device
also by clicking in the toolbar.
10.1.4 Options Menu
With the settings in the
Options
menu, only options are set that affect the operation of the DXConfig software. They
have no effect on the configuration of the devices.
10.1.4.1 Configuration
After selecting
Configuration
, the
Toolbox Configuration
window opens. The options are explained in detail in
the following table.
You can select this option also by clicking in the toolbar.