HI, MI, WI 700 service manual - 1 - Installation
1-11 Issue 9 04/2020
Installation
Machine feet
Once the machine has had any packaging removed, place the machine in its required position.
Fitting labeller to labeller arm
The labeller may have been removed from the labeller arm for transportation. Replace labeller onto the arm
as follows -
Remove the end plate and the two M8 cap head screws, Slide the labeller on to the labeller arm
Refit the two M8 screws into the labeller arm and the end plate
With the machine in position, lower
the feet. Level the machine and
ensure all feet are firmly on the solid
ground
For a HI machine which has two
frames, ensure both frames are level
with each other
Tighten the locking nut on each foot
To Next Page
Loading...