HI, MI, WI-700 service manual - 2 - component parts
2-57 Issue 9 04/2020
HS blow applicator
The HS blow applicator is a high
speed blow type application
Refer to section 4 serving for set-
up instruction for this applicator (or
refer to work instruction WI-449.1)
Remove the applicator rear cover
to access the pneumatic for the
applicator
Blow bar air flow
To aid good label placement onto the label receiver, the blow bar should have a suitable air flow set and its
air jet holes positioned at the correct angle for best transfer of label onto the receiver.
Important - the blow bar fitted to the labeller when using the HS blow applicator is a dedicated one for this
applicator - see below
Use this one with HS
blow applicator
Std blow bar -
not for HS blow
applicator
To Next Page
Loading...