Digi XBee User Manual

API Operation Frame descriptions XBee/XBee-PRO® S2C ZigBee® RF Module 195
Status code descriptions
The following table describes the various Verbose Join trace messages in Status Code order. The Transparent mode string column shows the string which
appears if you run Verbose Join in Command Mode. The Description column gives a more detailed explanation of each particular message. When a
message accompanies Status Data, the Status Data column shows how to parse the hexadecimal string into fields. The number of bytes per field appears
in parentheses “()”.
Status
code
Transparent
mode string Description Status data Description
0x00 Rejoin A join attempt is being started. rejoinState(1) The rejoinState is a count of join attempts.
0x01 Stack Status Shows status and state. EmberStatus(1)
0x00 - no network
0x01 - joining
0x02 - joined
0x03 - joined (no parent)
0x04 - leaving
emberNetworkStat
e(1)
0x90 - Network is up and ready to receive/transmit.
0x91 - Network is down and cannot receive/transmit.
0x94 - Join attempt failed.
0x96 - A node's attempt to re-establish contact with the
network after moving failed.
0x98 - A join attempt as a router failed due to a ZigBee
2006 versus ZigBee PRO 2007 incompatibility. Try to join
as an end device.
0x99 - The network ID has changed.
0x9A - The PAN ID has changed.
0x9B - The channel has changed.
0xAB - No beacons were received in response to a beacon
request.

Digi XBee Specifications

General

Operating Frequency	2.4 GHz
RF Data Rate	250 kbps
Model	XBee S2C
Category	Control Unit
Operating Voltage	2.1 to 3.6V DC
Operating Temperature	-40 to +85 °C
Interface	UART
Dimensions	24.38 x 27.61 x 9.14 mm