Digi XBee3 802.15.4

AT commands UART interface commands
Digi XBee3® 802.15.4 RF Module User Guide
101
Parameter Description
1 API enabled
2 API enabled (with escaped control characters)
Default
0
AO command
The API data frame output format for RF packets received.
Use AO to enable different API output frames.
Parameter range
0 - 2
Parameter Description
0 API Rx Indicator - 0x90, this is for standard data frames.
1 API Explicit Rx Indicator - 0x91, this is for Explicit Addressing data frames.
2
Legacy 802.15.4 API Indicator - 0x80/0x81. Also restricts the Digital Input sampling to
D0 through D8 and allows for OTA compatibility with legacy S1 and S2C devices.
Default
2
AZ (Extended API Options)
Optionally output additional ZCL messages that would normally be masked by the XBee application.
Use this when debugging OTA firmware updates by enabling client-side messages to be sent out of
the serial port.
Parameter range
0 - 2
Parameter Description
0 Suppress ZCL output
1 Reserved
2 Output supported ZCLpackets
Default
0