Digi XBee3 802.15.4

AT commands I/O line passing commands
Digi XBee3® 802.15.4 RF Module User Guide
121
Parameter range
0 - 0xFF
Default
0
T5 command
Specifies how long pin D5 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0
T6 command
Specifies how long pin D6 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0
T7 command
Specifies how long pin D7 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0
T8 command
Specifies how long pin D8 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0