Digi XBee3 802.15.4 User Manual

AT commands Custom default commands
Digi XBee3® 802.15.4 RF Module User Guide
126
Note Once you issue a WR command, do not send any additional characters to the device until after
you receive the OK response. Use the WR command sparingly; the device’s flash supports a limited
number of write cycles.
Parameter range
N/A
Default
N/A
RE command
Restore device parameters to factory defaults.
Does not exit out of Command mode.
Parameter range
N/A
Default
N/A
Custom default commands
The following commands are used to assign custom defaults to the device. Send RE command to
restore custom defaults. You must send these commands as local AT commands, they cannot be set
using Remote AT Command Request frame - 0x17.
%F (Set Custom Default)
When %F is received, the XBee3 802.15.4 RF Module takes the next command received and applies it
to both the current configuration and the custom defaults, so that when defaults are restored with RE
command the custom value is used.
Parameter range
N/A
Default
N/A
!C (Clear Custom Defaults)
Clears all custom defaults. This command does not change the current settings, but only changes the
defaults so that RE command restores settings to the factory values.
Parameter range
N/A
Default
N/A

Digi XBee3 802.15.4 Specifications

General

Brand	Digi
Model	XBee3 802.15.4
Category	Control Unit
Language	English