Digi XBee3 802.15.4 User Manual

Frame descriptions AT Command Response frame - 0x88
Digi XBee3® 802.15.4 RF Module User Guide
151
AT Command Response frame - 0x88
Description
A device sends this frame in response to an AT Command Frame - 0x08 and a AT Command - Queue
Parameter Value frame - 0x09. Some commands send back multiple frames; for example, the ND
command. This command ends by sending a frame with a status of 0 (OK) and no value. In the
particular case of ND, a frame is received via a remote node in the network and when the process is
finished, the AT command response is received. For details on the behavior of ND, see ND command.
Format
The following table provides the contents of the frame. For details on frame structure, see API frame
format.
Framedata
fields Offset Description
Frame type 3 0x88
Frame ID 4
Identifies the data frame for the host to correlate with a subsequent request
(0x08 or 0x09). If set to 0 in the request frame, the device does not send a
response.
AT
command
5-6 Command name: two ASCIIcharacters that identify the command.
Command
status
7
0 = OK
1 = ERROR
2 = Invalid command
3 = Invalid parameter
4 = Tx failure
Command
data
The register data in binary format. If the host sets the register, the device
does not return this field.
Example
If you change the BD parameter on a local device with a frame ID of 0x01, and the parameter is valid,
the user receives the following response.
Frame data
fields Offset Example
Start delimiter 0 0x7E
Length MSB 1 0x00
LSB 2 0x05

Digi XBee3 802.15.4 Specifications

General

Brand	Digi
Model	XBee3 802.15.4
Category	Control Unit
Language	English