Digi XBee3 802.15.4 User Manual

Frame descriptions Remote Command Response frame - 0x97
Digi XBee3® 802.15.4 RF Module User Guide
164
Remote Command Response frame - 0x97
Description
If a device receives this frame in response to a Remote Command Request (0x17) frame, the device
sends an AT Command Response (0x97) frame out the serial interface.
Some commands, such as the ND command, may send back multiple frames. For details on the
behavior of ND, see ND command.
Format
The following table provides the contents of the frame. For details on frame structure, see API frame
format.
Frame data fields Offset Description
Frame type 3 0x97
Frame ID
4
This is the same value that is passed into the request.
The request is a 0x17 frame.
64-bit source (remote)
address
5-12 The long address of the remote device returning this
response.
16-bitsource(remote)
address
13 -
14
The short address of the remote device returning this
response.
AT commands
15-16
The name of the command.
Command status
17
0 = OK
1 = ERROR
2 = Invalid Command
3 = Invalid Parameter
4 = Remote Command Transmission Failed
Command data
18-n The value of the requested register in hexadecimal notation
(non-ASCII).

Digi XBee3 802.15.4 Specifications

General

Brand	Digi
Model	XBee3 802.15.4
Category	Control Unit
Language	English