Digi XBee3 802.15.4 - Diagnostic Commands - FirmwareHardware Information; VR Command; VL Command; VH Command

AT commands Diagnostic commands - firmware/hardware information
Digi XBee3® 802.15.4 RF Module User Guide
123
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF
Diagnostic commands - firmware/hardware information
The following AT commands provide information about the device's hardware and firmware.
VR command
Reads the firmware version on a device.
Parameter range
0x2000 - 0x2FFF
Default
Set in the firmware
VL command
Shows detailed version information including the application build date and time.
Parameter range
N/A
Default
N/A
VH command
Reads the bootloader version of the device.
Parameter range
N/A
Default
N/A
HV command
Display the hardware version number of the device.
Parameter range
0 - 0xFFFF [read-only]
Default
Set in firmware