Digi XBee3 802.15.4

AT commands I/O line passing commands
Digi XBee3® 802.15.4 RF Module User Guide
120
Default
1
T0 command
Specifies how long pin D0 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0
T1 command
Specifies how long pin D1 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0
T2 command
Specifies how long pin D2 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0
T3 command
Specifies how long pin D3 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.
Parameter range
0 - 0xFF
Default
0
T4 command
Specifies how long pin D4 command holds a given value before it reverts to configured value. If set to
0, there is no timeout.