EasyManuals Logo

Digi XBee3 802.15.4 User Manual

Digi XBee3 802.15.4
185 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Modes Idle mode
Digi XBee3® 802.15.4 RF Module User Guide
31
2. If the device does not receive any valid AT commands within the time specified byCT
command, it returns to Transparent or API mode. The default Command mode timeout
is10seconds.
For an example of programming the device using AT Commands and descriptions of each configurable
parameter, see AT commands.
Idle mode
When not receiving or transmitting data, the XBee3 802.15.4 RF Module is in Idle mode. During Idle
mode, the device listens for valid data on both the RF and serial ports.
If configured for Sleep support, the XBee3 802.15.4 RF Module only transitions to a low power state
when in Idle mode.
Transmit mode
Transmit mode is the mode in which the device is transmitting data. This typically happens after data
is received from the serial port.
Receive mode
This is the default mode for the XBee3 802.15.4 RF Module. The device is in Receive mode when it is
not transmitting data. If a destination node receives a valid RF packet, the destination node transfers
the data to its serial transmit buffer.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi XBee3 802.15.4 and is the answer not in the manual?

Digi XBee3 802.15.4 Specifications

General IconGeneral
BrandDigi
ModelXBee3 802.15.4
CategoryControl Unit
LanguageEnglish

Related product manuals