Digi XBee3 802.15.4 User Manual

Get started Assemble the hardware
Digi XBee3® 802.15.4 RF Module User Guide
15
The kit includes several XBee Grove Development Boards. For more information about this hardware,
see the XBee Grove Development Board documentation.
Plug in the XBee3 802.15.4 RF Module
This kit includes two XBee Grove Development Boards. For more information about this hardware,
visit the XBee Grove Development Board documentation.
Follow these steps to connect the XBee devices to the boards included in the kit:
1. Plug one XBee3 802.15.4 RF Module into each XBee Grove Development Board. When you
connect the development board to a PC for the first time, the PC automatically installs drivers,
which may take a few minutes to complete.
CAUTION! Never insert or remove the XBee while the power is on (either from the
micro USB or a battery)!
For XBee SMT devices, align all XBee pins with the spring header and carefully push the device
until it clicks firmly into the board.

Digi XBee3 802.15.4 Specifications

General

Brand	Digi
Model	XBee3 802.15.4
Category	Control Unit
Language	English