Digi XBee3 802.15.4

Get started Configure remote devices
Digi XBee3® 802.15.4 RF Module User Guide
17
3. Configure the first device in API mode and name it XBEE_A by configuring the following
parameters:
n ID: 2018
n NI: XBEE_A
n AP: API enabled [1]
4. Configure the second device in either API or Transparent mode, and name it XBEE_B by
configuring the following parameters:
n ID: 2018
n NI:XBEE_B
n AP: 0 or 1
4. Disconnect XBEE_B from your computer and remove it from XCTU.
5. Connect XBEE_B to a power supply (or laptop or portable battery).
The Radio Modules area should look something like this.
6.
Select XBEE_A and click the Discover radio nodes in the same network button .
7. Click Add selected devices in the Discovering remote devices dialog. The discovered remote
device appears below XBEE_A.
8. Select the remote device XBEE_B, and configure the following parameter:
LT: FF (hexadecimal representation for 2550 ms)
9.
Click the Write radio settings button .
The remote XBee device now has a different LED blink time.
10. To return to the default LED blink times, change the LT parameter back to 0 for XBEE_B.