Digi XBee3 802.15.4 User Manual

Digi XBee3® 802.15.4 RF Module User Guide
9
T6 command 121
T7 command 121
T8 command 121
T9 command 122
Q0 command 122
Q1 command 122
Q2 command 122
PT (PWM Output Timeout) 122
Diagnostic commands - firmware/hardware information 123
VR command 123
VL command 123
VH command 123
HV command 123
%C (Hardware/Software Compatibility) 124
%V command 124
TP command 124
DD command 124
CK command 124
FR command 125
Memory access commands 125
AC (Apply Changes) 125
WR command 125
RE command 126
Custom default commands 126
%F (Set Custom Default) 126
!C (Clear Custom Defaults) 126
R1 (Restore Factory Defaults) 127
Operate in API mode
API mode overview 129
Use the AP command to set the operation mode 129
API frame format 129
API operation (AP parameter = 1) 129
API operation with escaped characters (AP parameter = 2) 130
Frame descriptions
TX Request: 64-bit address frame - 0x00 134
TX Request: 16-bit address - 0x01 135
AT Command Frame - 0x08 136
AT Command - Queue Parameter Value frame - 0x09 138
Transmit Request frame - 0x10 138
Explicit Addressing Command frame - 0x11 140
Remote AT Command Request frame - 0x17 144
RX Packet: 64-bit Address frame - 0x80 145
Receive Packet: 16-bit address frame - 0x81 146
RX (Receive) Packet: 64-bit address IO frame - 0x82 147
RX Packet: 16-bit address I/O frame - 0x83 149
AT Command Response frame - 0x88 151
TX Status frame - 0x89 153
Modem Status frame - 0x8A 155
Transmit Status frame - 0x8B 156
Receive Packet frame - 0x90 158

Digi XBee3 802.15.4 Specifications

General

Brand	Digi
Model	XBee3 802.15.4
Category	Control Unit
Language	English