How to troubleshoot a Digisol DG-FS1526 Switch when the power indicator is not on?
If the power indicator on your Digisol Switch is not on after starting the system, ensure the power is correctly connected. Also, verify that the power switch is turned on.
What to do if the power indicator is on but the Ethernet indicator is off on my Digisol DG-FS1526 Switch?
If the power indicator on your Digisol Switch is on, but the Ethernet indicator is off, first verify that the network cable is properly connected. If the connection is good, check to ensure that the configuration settings are correct.
General| Switching Capacity | 8.8 Gbps |
|---|---|
| Forwarding Rate | 6.5 Mpps |
| MAC Address Table | 8K |
| Jumbo Frame | Up to 9K Bytes |
| Dimensions | 440 x 44 mm |
| Operating Temperature | 0°C to 45°C |
| Storage Temperature | -40°C to 70°C |
| Operating Humidity | 10% to 90% non-condensing |
| Storage Humidity | 5 to 90 % |
| Ports | 24 x 10/100BASE-TX ports, 2 x 10/100/1000BASE-T ports, 2 x 1000BASE-X SFP ports |
| Power Consumption | ≤ 15W |
Lists the key capabilities and specifications of the switch.
Details the operating and storage conditions for the device.
Specifies the input voltage and frequency for the power supply.
Indicates the maximum power draw of the device.
Describes the types, speeds, and standards of network ports.
Provides the dimensions and weight of the switch.
Outlines necessary steps and items before beginning installation.
Details the physical components and layout of the switch.
Instructions for connecting power and network interfaces.
Pre-operational checks to ensure correct setup.
Steps to safely power on and initialize the switch.
Steps to ensure network readiness for accessing the web interface.
Procedures for accessing the device's web management interface.
Overview of system configuration and maintenance options.
Manages individual switch ports and their configurations.
Manages virtual LANs for network segmentation and security.
How to select between Port Based or Tag Based VLAN modes.
How to assign ports to specific VLAN groups.
How to configure multi-to-1 VLAN for enhanced security.
How to view traffic statistics and packet counts per port.
Manages Quality of Service for network traffic prioritization.
How to configure different packet priority queuing methods.
COS settings based on port, 802.1p, or IP/DS.
COS settings based on TCP/UDP port.
Configures network security features like access control.
How to bind specific MAC addresses to switch ports.
How to filter network traffic based on TCP/UDP protocols.
Manages Spanning Tree Protocol to prevent network loops.
How to configure Spanning Tree Protocol bridge parameters.
How to configure Spanning Tree Protocol port parameters.
How to enable detection of loopback connections on ports.
Configures link aggregation for increased bandwidth and redundancy.
How to configure link aggregation for increased bandwidth and redundancy.
Manages DHCP relay services for network clients.
How to specify DHCP server addresses for relay.
How to map VLAN IDs to DHCP relay servers.
How to save and restore the switch configuration.
Settings for VLAN striding and uplinks.
How to configure Simple Network Management Protocol parameters.
Procedure for exiting the management session.
To Next Page
