DG-SC2100/DG-SC2100W User Manual
15
5. In ‘IP address’ field, please fill in any IP address that begins with ‘192.168.2’, and
ends with a value greater than 2 and less than 254 (You can use the example in the
picture ‘192.168.2.239’). In the Subnet mask field, please fill ‘255.255.255.0’.
Please keep all other fields empty, and click ‘OK’.
If you changed the IP address of this IP camera and you cannot recollect it, there are 2
methods to recover it:
a. Press and hold the ‘Reset’ button located at the bottom of this IP camera, to
clear all settings of the IP camera and reset the IP address back to
192.168.2.3. You’ll lose all settings in the IP camera.
b. Ask the network administrator to check the DHCP release table, if the camera
was set to obtain the IP address by DHCP, a new record will be added to the
DHCP release table on the DHCP server. (when the IP camera is connected to
the local area network)
To Next Page
Loading...
