DG-SC2100/DG-SC2100W User Manual
40
WPA Pre-Shared Key Input the WPA pre-shared key here.
This field is only available when authentication type is
WPA-PSK or WPA2-PSK, and will be grayed out
when other authentication type is selected.
WEP Key Length Please select the key length when you use WEP
encryption. Available options are 64-bit and 128-bit.
Selecting ‘128-Bit’ is safer, however, it would make
the network a bit slower.
If the key length is 64-bit, you should input 10 HEX
characters or 5 ASCII characters, like 112233aabb
(HEX) or MYWEP (ASCII).
If the key length is 128-bit, you should input 26 HEX
characters or 13 ASCII characters, like
11223344556677889900abcdef (HEX) or
myweppassword (ASCII).
WEP Key Format Select the Key Format of WEP key here. Available
options are ‘HEX’ and ‘ASCII’.
When you select ‘HEX’ WEP key format, you can only
use numbers (0 to 9), and alphabets a to f as WEP key;
when you select ‘ASCII’ WEP key format, you can use
all alphanumerical characters, and is case sensitive.
Default Key Select the default key set that the IP camera should use
for connecting to the wireless access point when WEP
encryption is used.
Available options are 1 to 4.
WEP Key 1 Input the 1st set of WEP key here. At least one set of
WEP key is required when WEP encryption is used.
Only 1st WEP key should be used if there is only one
WEP key.
WEP Key 2 Input the 2nd set of WEP key here.
WEP Key 3 Input the 3rd set of WEP key here.
WEP Key 4 Input the 4th set of WEP key here.
Click ‘Apply’ to save settings and make the new settings take effect.
To Next Page
Loading...
