Digisol DG-SC2100 - Page 80

DG-SC2100/DG-SC2100W User Manual
80
Edit Select an email address from ‘Recipient E-Mail Address’ box,
and click ‘Edit’ to edit the email address.
Delete Delete selected email address.
Sender E-Mail
Address
Specify the email address of email sender.
SMTP Server Specify the IP address or host name of the SMTP server you
wish to use. For most of ISPs they will only allow its
subscriber to use their SMTP server, if you don’t know which
SMTP server you should use, please refer to the setting of your
email software or ask your ISP / network administrator.
SMTP port Specify the port number of the SMTP server you wish to use
here. By default (and the setting of most of SMTP servers) it is
‘25’.
SMTP Auth Select ‘Enable’ if your SMTP server requires authentication,
select ‘Disable’ if it’s not required. If you don’t know if your
SMTP server requires authentication, please refer to the setting
of your email software or ask your ISP / network
administrator.
SMTP Account Input the SMTP account (username) of your SMTP server
here. In most cases, it’s the same as your POP3 username (the
one you use to receive email). Please refer to the setting of
your email software or ask your ISP / network administrator if
you’re not sure about this.
SMTP Password Input the SMTP password of your SMTP server here. In most
cases, it’s the same with your POP3 password (the one you
used to receive email). Please refer to the setting of your email
software or ask your ISP / network administrator if you’re not
sure about this.
SMTP SSL/TLS If your email server requires SSL encryption, select SSL or
TLS options available in the list.
OK Save settings in this tab.
Cancel Discard all changes done in this tab.