TellerScan
®
TS240 User Manual
Rev 122013
Page | 19
TellerScan TS240 Routine Maintenance
TellerScan TS240 Maintenance Overview
Over time, ink, dirt and dust particles will collect on the scanner rollers and in the document track. Therefore, it
is necessary to clean these areas to ensure reliable performance.
Perform a periodic inspection of the document track and use a Digital Check cleaning card to clean the
scanner rollers. Using a can of compressed air will help keep the document track clean.
Inspect the quality of the captured images on a regular basis. If the image quality drops off, clean the camera
glass by following the procedure below.
Inspect the TS240 Document Track
In addition to routine drive roller cleaning, a periodic inspection of the entire document track area is also
recommended. The use of a flashlight will enhance the visual inspection in the camera section and throughout
the document track. Remove any staples, paperclips, debris etc. that might have accumulated during use.
Have a can of compressed air available to blow out the document track on a regular basis. Blow the dust
toward the entry and exit pockets starting from the center of the path by the ink cartridge platform.
Cleaning the TS240 Camera
To clean the cameras, use a Digital Check cleaning swab or a clean cloth to wipe the camera glass. Be careful
not to scratch the glass when cleaning or accessing the camera for any reason. See the ‘Accessing the
Cameras’ section for additional information on opening the assembly prior to cleaning.
To Next Page
Loading...
Need help?
General
