Digital Check TellerScan TS240 - TellerScan TS240 Initial Setup; New User Notice; Cable Connections and Scanner Placement

TellerScan
®
TS240 User Manual
Rev 122013
Page | 7
TellerScan TS240 Initial Setup
New User Notice
PLEASE NOTE: Do not connect the ‘USB’ cable from the scanner to your PC before installing the ‘drivers’ or
the ‘scanning application / software’. Digital Check does not provide scanning software. Please contact your
bank or other solution provider for further assistance with installing the driver or getting the scanning software
set up or installed.
Digital Check provides only an optional driver installation utility and a separate demonstration program.
See the ‘Installing the Optional USB Driver’ section or the ‘Installing Scanlite2’ section for additional
information.
Cable Connections and Scanner Placement
Note: Do not connect the ‘USB’ cable from the scanner to your PC before installing the ‘drivers’ or the
‘scanning application / software’.
 Place the unit on a flat surface near the PC and away from direct light sources such as spot lights or desk
lamps. Place the scanner in a position that is at least 6 inches away from any power supply, other
electronic devices, pneumatic tubes at the teller window, etc.
 Connect the ‘Power Cord’ for the external ‘Power Supply’ to the ‘Power Supply’ and then plug the
connector into the rear ‘Power Connection’ port.
 Connect the ‘USB’ cable by plugging it into the rear USB port.