TellerScan
®
TS240 User Manual
Rev 122013
Page | 9
Installing the 1 Line Printer Ink Cartridge (continued)
Step 3: Insert the nozzle end of the cartridge into the platform while keeping the end of the cartridge tilted
slightly upward. Push down on the rear of the cartridge until it clicks twice and snaps into position.
Step 4: Verify that the cartridge is properly installed. The cartridge should appear tilted at a slight angle when
fully seated. Replace the ‘Center Cover’ by setting it back on the unit vertically.
Note: If the scanner has to be transported by common carrier from one place to another or will experience
extended periods of inactivity, it is advisable to remove the ink cartridge from the scanner and seal it in an
airtight bag. If the cartridge has not been used for an extended period of time, it might be necessary to clean
the inkjet nozzles by gently blotting them with a towel dampened with water or using Digital Checks Inkjet
Cleaning Swabs (PN: IS0032 – available at www.digitalcheck.com).
To Next Page
Loading...
Need help?
General
