Digital Dream DDCS V3.1 - Page 63

Digital Dream Standalone Motion Controller DDCS V3.1 DDCS V3.1 Users Manual Page -62
3.5 Keyboard Operation Methods
In the new version of 3.1,in order to supply more convenient operation options for custom-
ers,the users not only can use the controller Panel to operate,but also can use the keyboard and
MPG.Here we describe the operation methods by keyboard.
Important： Please select the keyboard with USB connection,and with numerical pad.The
following Figure is for your references:
Centering operation
X-
X+
Y-
Y+
Z-
Z+
A-
A+
1：LEFT ARROW(←)
2：Numeric keypad '4'
1：DOWN ARROW(↓)
2：Numeric keypad '2'
1：RIGHT ARROW(→)
2：Numeric keypad '6'
1：UP ARROW(↑)
2：Numeric keypad '8'
1：PAGEDOWN
2：Numeric keypad '3'
1：PAGEUP
2：Numeric keypad '9'
Numeric keypad '1'
Numeric keypad '7'
Used in conjunction with the MPG axis selection. Only when the
MPG axis is selected as X or Y, the corresponding axis performs
the centering operation
F3
1：X Axis Moves to Left Side;
2：Cursor Moves Left;
1：X Axis Move to right Side;
2：Cursor Move right;
1：Y axis moves to forward side;
2：Increase the numbers;
1：Y Axis moves to back side;
2：Decrease the numbers;
1：Z Axis moves up;
2：In File and Param page moves Up the selection;
1：Decrease at A Axis
1：Increase at A Axis
1：Z Axis moves down;
2：In File and Param page moves down the selection;
Function Keys on Keyboard Operation Methods
Figure 3-72 The USB Keyboard