Digital Dream Standalone Motion Controller DDCS V3.1 DDCS V3.1 Users Manual Page -63
Numeric keypad“5”
Manual mode
switching
Jog distance
adjustment
FRO adjustment
SRO adjustment
1：F10
2：Numeric keypad '*'
Zero
1：F6
2：Numeric keypad 'DEL'
The first press enters the HOME mode. In the HOME mode,
press again to perform full axis HOME, or press the corresponding
axis selection key, the corresponding axis perform HOME separately:
HOME X-axis selection:'X'
HOME Y-axis selection:'Y'
HOME Z-axis selection:'Z'
HOME A-axis selection:'A'
The first press enters PROBE mode and presses again to
perform the PROBE operation
Same function of “Mode”in controller panel，shift among
“CONT”、“STEP”、“MPG”
#2020，#2021，#2022，#2023 can define the Jog distance.
The Key is to shift among the 4 distance.
Can define the F value as the current feeding speed,or cancel F
value as the current speed（current speed set by G-code file)
Can define the S value as the current feeding speed,or cancel S
value as the current speed（current speed set by G-code file)
Start a G-code file processing
Pause a processing job.
Shift among the coordinate system.
When controller in Auto mode,Press it will enter into Try Cut
mode,need to work with MPG.
The single-segment mode can be switched while the system is
idle. After starting the machining in single-segment mode, the
system executes one line each time the start button is pressed.
Same function of “Shift”on Controller Panel.
Increase Numbers in controller system;
decrease Numbers in controller system;
Same funciton as “Page”on controller Panel.
Display or cancel the ToolPath.
Popup USB-Stick from Controller system.
Home
PROBE
F7
F8
Function Keys on Keyboard Operation Methods
Goto Zero
1：F5
2：Numeric keypad '0'
Used in conjunction with the MPG axis selection. If the MPG
axis is selected to be empty, the whole axis will goto zero. If
the MPG axis is selected as X, the X axis will goto zero.
Used in conjunction with the MPG axis selection.If the MPG
axis is selected to be empty, the whole axis will be zero. If the
MPG axis is selected as X, the X axis will be zero.)
Coordinate system
Selection
START
PAUSE
TRY CUT:
Single-Stage
processing mode
Focus TAB
Focus adjustment+:
Focus adjustment-
Page switching
ToolPath display
Uninstall U disk
1：Main keyboard“F”
2：Main Keyboard“8”
1：Main Keyboard“S”
2：Main Keyboard“9”
1：Main Keyboard“G”
2：Main Keyboard“0”
1：SCROLL LOCK
2：Numeric keypad '-'
1：PAUSE BREAK
2：Numeric keypad '+'
1：F9
2：Numeric keypad '/'
Main Keyboard“-”
1：F11
2：Numeric keypad
“ENTER”
1：TAB
2：BACKSPACE
F4
Main Keyboard“+”
F12
Main keyboard‘DELETE’
To Next Page
Loading...
