Digital Dream DDCS V3.1 - Page 65

Digital Dream Standalone Motion Controller DDCS V3.1 DDCS V3.1 Users Manual Page -64
4.1 The detailed definition of parameters
4 Parameter Instruction
#5: If your controller is 4 axes with A axis,the A axis will rotate in the speed of F(recombination Speed).But when the
radius is a unlimited small value,the A axis rotating speed will be unlimited-high,that will cause problems.In the
situation,we set the min radius is 3,to avoid the situation.
#6: This value optimaze algorithm of A axis.Depend on the selection,we can project the rotating arc line on to X or Y
or Z axis with F value.If select “not rotate”,this algorithm is not active.
#416: After years experience and debugging,7000 is a suitable value for stepper system.
1) Top Parameters (Totally 3 items)
2) Motor Parameters（Totally 16 items）
0=No,1=Yes
0=X axis,1=Y axis,
2=Z axis,3=not rotate
5
3
0
mm 3~999.999
0-3
1/0
#5
#6
#104
minimum log radius of 4 axis machining
A axis rotate reference axis
A axis optimal path when G0 run
Para.
Mark
Parameter definition
Default
value
Parameter
Unit
Parameter
Scope
Notes
0=pulse/deg,1=pulse/circle
0=A axis, 1=B axis
Direction is ahead of Pulse
50
2560
2560
2560
640
0
0
0
1
1
0
7000
0
0
0
0
mm/min
pulse/mm
pulse/mm
pulse/mm
pulse/mm
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
ns
BOOL
BOOL
BOOL
BOOL
0~999
50~99999.000
50~99999.000
50~99999.000
50~99999.000
0~9999.000
1/0
1/0
1/0
1/0
1/0
1/0
1/0
1/0
1/0
1/0
#33
#34
#35
#36
#38
#39
#40
#390
#391
#392
#393
#416
#418
#419
#420
#421
Motor start speed
X axis pulse equivalency
Y axis pulse equivalency
Z axis pulse equivalency
A axis pulse equivalency
A axis pulse unit
AB axis Selection
X axis DIR signal Electric Level
Y axis DIR signal Electric Level
Z axis DIR signal Electric Level
A axis DIR signal Electric Level
Time interval between DIR & PUL
X axis Pulse signal Electric Level
Y axis Pulse signal Electric Level
Z axis Pulse signal Electric Level
A axis Pulse signal Electric Level
The Pulses needed for
feeding 1mm
Para.
Mark
Parameter definition
Default
value
Parameter
Unit
Parameter
Scope
Notes
Motor Speed of first step
1=high, 0=low
1=high,0=low