Digital Dream Standalone Motion Controller DDCS V3.1 DDCS V3.1 Users Manual Page -82
Q7: When I have set the controller language to Eng in the Parameters Page, my controller still
displays in Chinese?
A: After setting a new language,please restart your controller,then your controller will display the
language which you set.
Q8: In the processing period,nothing happened even after I pressed any buttons.
A: The problem maybe from electromagnetic interference,the solutions are:
1： Don’t use the USB cable,just insert the USB memory stick into the controller USB port.
2： The metal part of the USB cable must not touch with the controller box,and also you can use a
Ferrite core on the USB cable to try to ignore the noise..
3：The wiring from the inverter to controller,please use the shielded cable,expecially the wiring
from the servo system to controller,the user must use the shielded cable,to avoid interference.
Q9: Can the Homing signal and Limit signal share one switch?
A: Yes you can.
Q10: Why is my toolpath display not compatible with the screen, or is my toolpath display frozen?
A: Whenyou use a new G-code file,and its the first time the controller runs the file,the toolpath
display maybe too small or too big for the screen,If this happens Please don’t display the
toolpath.Just let the controller run through the file completely.After this the controller will know
the size of the file, so next time the system can adjust the display accordingly and show a correctly
sized toolpath.
Q11: How can I Plug a USB-Stick and a Keyboard at the same time cause there is only 1 USB port
on the controller?
A: The users can use a USB Hub with more than 2 USB ports.The Picture for the references:
To Next Page
Loading...
