Document No. CO 004844K
6
stream that will be used for RFC2544 testing and confirm that pack-
ets are transmitted and received. While the button is in the on posi-
tion, the TX and RX packet count will not be equal. This is normal. It
is only necessary to determine that packets are being successfully
received to confirm basic connectivity before beginning lengthy RFC
2544 tests.
4. Press the on/off button again to turn the stream off.
5. Press RFC Tests, then Conf.
6. Press stream Id and select the number of the stream that was config-
ured in the earlier steps.
7. Press Trial Duration, if anything other than 60 seconds (standard, and
default) is required. For Back-to-Back Burst Testing, duration must
be 10 seconds or less.
8. To run Throughput Test, press ThruPut, then Start Test.
9. To run Frame Loss Test, press Frame Loss, then Start Test.
10. To run Back-to-Back Burst Test, press B2B Burst, then Start Test.
11. To save or print results, see Printing/Saving Results in this Quick
Reference Guide or in the Online Help Users’ Guide.
To Next Page
Loading...