Document No. CO 004844K
ii
Safety
The following safety precautions are provided to avoid injury
and prevent damage to this product or any products connected to
it during normal operation. Only trained and qualified mainte-
nance personnel should perform service procedures.
Use Proper Power Cord: To avoid fire hazard, use only the
power cord provided with the instrument. For international oper-
ation, use an HO5VV-F power cord with a 1-mm
2
, two conduc-
tor plus ground, IEC 320 connector on one end, and a wall-
socket plug on the other end that is certified for use in the coun-
try of installation. The entire cordset must be certified for use in
the country of installation.
Avoid Electric Overload: This unit is designed to be powered
from 100–120 and 200–240 VAC, 50–60 Hz. To avoid electric
shock, fire hazard, or damage to the instrument, do not apply a
higher or lower voltage.
Grounding: The unit is grounded through the grounding con-
ductor of the power cord. To avoid electric shock, the grounding
conductor must be connected to earth ground. Before making
connections to the input or output terminals of the instrument,
ensure that the product is properly grounded.
Do Not Operate in Hazardous Conditions: To avoid injury or
fire hazard, do not operate this instrument in wet, damp, or other
hazardous conditions. Do not operate this instrument in an
explosive atmosphere. This instrument is not intended for out-
door use.
Eye Protection: Users should never stare into unterminated
connectors or broken fibers. In addition, fiber cables and inter-
faces should always be handled as if they were emitting laser
light. Always leave protective covers on optical connectors to
prevent damage and prevent laser emissions.
Field Service: This equipment is not intended to be serviced in
the field. All service is intended to be completed by Digital
Lightwave, Inc.
To Next Page
Loading...