Digitize Inc. System Programming
700271-0001 Rev. G 05/13 31
Default Setting: Buzzer Timeout: 02 minutes
5.12 Function 9
Function 9 is not used for this version of the software.
5.13 Function 10
Function 10 is not used for this version of the software.
5.14 Function 11 Bulldog
Function 11 controls if the Bulldog feature is enabled or disabled. See Definitions.
Default Setting: Bulldog: Disabled
5.15 Function 12 Ground Mode
Function12 controls the Ground Mode feature. If the panel detects that the Telegraph Loop is
OPEN and Ground Mode is Enabled, the panel will go into Ground Loop Mode. The DET-
16 will activate the Ground Code relay and code the telegraph transmission to earth ground.
Default Setting: Ground Mode: Enabled
5.16 Function 13 Open / Closed Indexing
Function 13 sets the entire DET-16 panel to be either Open or Closed Indexing. The panel
must be set to match the type of indexing used by the telegraph loop decoder to work
properly. Open Indexing is normally the standard.
To Next Page
Loading...