DIGITIZE DET-16 - Function 17 Standby Mode; Function 18 Reset Factory Defaults; Function 19 AC Power Delay

Digitize Inc. System Programming
700271-0001 Rev. G 05/13 33
Default Setting: 60 Minutes
5.20 Function 17 Standby Mode
When enabled, Standby Mode prevents the panel from transmitting when a zone is activated.
Panel Testing can be conducted in Standby Mode. The Standby Timeout is the amount of
time the panel will remain in Standby (See Function 16).
5.21 Function 18 Reset Factory Defaults
Returns the entire panel back to the factory default settings. Press “1” then Enter.
5.22 Function 19 AC Power Delay
Function 19 will delay the report of an AC Power Failure at the panel for up to 255 minutes.
If the power is restored to the panel during this delay period, the panel will automatically
restore to a Normal condition.
Default Setting: 2 Minutes