The numbers will flash for a few seconds as the command station reads
back the data value in the decoder. The d means that you are looking
at the CV’s data value that is programmed into the decoder, in this
case the CV value is 0.
6. Use the NUMERIC KEY PAD to enter the new CV data value you
want to program into the decoder. For example if you want to pro-
gram the value of 2 for CV03 which controls acceleration, enter 02.
Note: If you do not want to read back the CV’s data value as described
in step 5, you can simply press the CV Key again to go directly to
the data entry mode. In this case, the display will show “d” followed
by 3 digits. When you see this display, use the KEY PAD to enter
the new data value you want to program.
7. Press CV-WR to write the new data value selected to the CV. The
display will flicker while the command station programs the decoder
and the display will show the data value programmed.
8. To program another CV, press the CV Key and enter the CV number
you want to program next and repeat steps 3-7 again.
9. When you are finished programming press the EXIT Key to resume
normal operations.
To Next Page
Loading...
