To Next PageTo Next Page
Need help?Do you have a question about the Digitrax Zephyr and is the answer not in the manual?
Basic troubleshooting tips for issues encountered during initial setup.
Details Service Mode programming on an isolated track and Operations Mode on the layout.
Steps for choosing address mode, reading current address, and writing a new address to the decoder.
Procedures for selecting CVs, entering data, reading values, and writing to the decoder.
Procedure to input the CV number for programming in Operations Mode.
How to input the data value for the selected CV in Operations Mode.
Saving the programmed CV data value back to the decoder.
How to control speed with the throttle knob and set a speed limit for the local throttle.
How to change locomotive direction and use the brake function with the Direction Lever.
Procedures for stopping individual locomotives and performing an emergency stop for the entire layout.
How to use the brake function and adjust the brake rate parameter.
Explains DCC functions and how to operate F0-F8 using the keypad.
Checks and steps to take if locomotive functions are not responding as expected.
Step-by-step guide to forming an MU consist and adding locomotives to it.
Steps to remove a locomotive from an existing MU consist.
Step-by-step guide to changing a decoder's speed step compatibility via status editing.
Troubleshooting steps for unresponsive systems, power issues, and using the Quarter Trick.
Comprehensive checks for decoders that are not responding, including address, power, MU status, and CVs.
Introduction to option switches and the procedure for changing their settings.
General| Control | DCC |
|---|---|
| Throttle | Integrated |
| LocoNet | Yes |
| Manufacturer | Digitrax |
| Programming Track Output | Yes |
| Computer Interface | LocoNet |
| Display | LCD |
| Number of Accessory Addresses | 20 |
| Number of Throttles | LocoNet |
| Command Station | Integrated |
| Booster | Integrated |
| Interface | LocoNet |
| Compatibility | NMRA DCC |
