EasyManua.ls Logo

Digitrax Zephyr - 30 Warranty and Repair Information

Digitrax Zephyr
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different form that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Note that any modifications to the equipment not expressly approved by
Digitrax voids the users authority to operate under and be in compliance with
CFR 47 rules, as administered by the Federal Communication Commission.
Digitrax believes any conscientiously installed equipment following guidelines
in this manual would be unlikely to experience RFI problems.
The DT400R is certified for “unlicensed” operations within the United States
by the US FCC and has the identifier: FCC ID: LV3RF1 or other as displayed
on the unit case. Canadian ID for DT400R is 3015102960. See unit case for
certification identifiers from other countries.
The UR91 is certified for “unlicensed” operations within the United States by
the US FCC and has the identifier: FCC ID: LV3UR91 or other as displayed on
the unit case. Canadian ID for UR91 is 30151002940A. See unit case for certi-
fication identifiers from other countries.
Important Note: The DT400R is certified by the FCC and by Industry Canada
using a 12” LocoNet cable only. Any modification to the cable may void the
certification. For convenience an extension cord may be attached with a 6 pin
adapter for tethered use only.
For Canadian Users:
“This digital apparatus does not exceed the Class B limits for Radio noise
emission from digital apparatus set out in the Radio Interference Regulation or
the Canadian Department of Communications.”
Le present appariel numerique n emet pas de bruits radio-electriques depassant
les limites applicables aux appareils numeriques de la classe B prescrites dans
le Reglement sur le brouillage radioelectrique edicte par le ministere des
Communications du Canada.
30.0 Warranty and Repair Information
Digitrax gives a one year guarantee against manufacturing defects on the
DCS50 and PS315. These units are not user serviceable (opening the case
voids your warranty). If a defect occurs, return the unit to us for service. We
53

Table of Contents

Related product manuals