1
1.0 Introduction 3
2.0 Zephyr Components 3
3.0 Preparing Your Locomotives 3
4.0 Preparing Your Layout 3
5.0 Zephyr Hook Up-As Easy As 1-2-3! 4
6.0 DCS50 Front Panel Controls And Indicators 6
7.0 DCS50 LED Display 8
8.0 Run A Locomotive Without a DCC Decoder 9
9.0 Run A DCC Equipped Locomotive 10
10.0 Shutting Down the System 12
11.0 Resuming Operation 13
12.0 Quick Start Troubleshooting 13
13.0 Decoder Programming 14
13.1 Setting Up A Service Mode Programming Track 15
13.2 Using the Programming Track to Change the Decoder Address 17
13.3 Using The Programming Track To Program CVs Other Than
Addresses 19
13.4 Programming On The Mainline: Operations Mode Programming
21
13.5 Programming Error Messages 22
13.6 Reading Back CV Values Programmed 23
14.0 Locomotive Speed Control 24
14.1 Speed Limit 24
15.0 Locomotive Direction Control 25
15.1 Setting A Loco to Zero Speed 25
15.2 Brake Operation 25
15.3 Emergency Stop 26
16.0 Functions 27
16.1 Controlling Functions F0-F8 27
16.1.1 Function 0 (F0) 27
16.1.2 Functions 1, 4, 5, 6, 7, & 8 28
16.1.3 Function 2 (F2) 28
16.1.4 Function 3 (F3) 28
16.2 Function Operation Troubleshooting 29
17.0 MU (Multiple Unit) Operations 29
17.1 Adding a Locomotive To An MU 30
17.2 Removing A Loco From An MU 31
17.3 MU of Mismatched Locomotives 32
17.4 Controlling Functions On MU’ed Locomotives 32
18.0 Stealing: When An Address Is Running on Another Throttle 33
Digitrax Zephyr Set Manual
Includes DCS50 Command Station,
PS315 Power Supply and LT1 LocoNet Cable & Decoder Tester
Table of Contents
To Next Page
Loading...
