19.0 Releasing An Address From A Throttle 34
19.1 Dispatching Addresses or MUs 34
20.0 The FuLL Message 35
21.0 DCS50 Error Messages 36
22.0 Decoder Speed Step Settings 36
22.1 Changing Speed Step Settings: Status Editing 37
23.0 SWITCH Mode 38
24.0 Adding Throttles: LocoNet & Jump Ports 39
24.1 Adding LocoNet Throttles To Your DCS50 39
24.2 Jump Ports: Using A Smooth DC Power Pack As An Additional
Throttle 40
24.3 Adding Another DCS50 45
24.3.1 Making LocoNet Cables 47
25.0 Shut Down Procedures 48
26.0 Troubleshooting 48
26.1 Nothing is responding 48
26.2 No Power or Intermittent Operation 48
26.2.1 The Quarter Trick 48
26.2.2 The LT1 Tester 49
26.3 Emergency Stop 49
26.4 Mechanical Drive Train Problems 49
26.5“Strange” Locomotive Lights 49
26.6 Decoder Won’t Respond 49
26.7 I’m totally lost! 50
26.8 DCS50 Shutdown 50
27.0 DCS50 Option Switch Setup 51
28.0 LocoNet: The Digitrax Difference! 52
28.1 System Architecture 53
29.0 FCC Information 54
30.0 Warranty and Repair Information 55
2
Digitrax, the Digitrax Train Logos, LocoNet, Super Empire Builder, Super
Chief, Transponding, SuperSonic, AutoReversing, Zephyr, Jump & others are
trademarks of Digitrax, Inc. This manual may not be reproduced in any form or
translated into other languages without Digitrax permission.
©Digitrax, Inc. All Rights Reserved. Printed in USA REV 11/03
Components included in the Zephyr set are covered by US Patents
6,275,739, 6,536,716, 6,220,552 B1, 6,318,678 B2, 6,533,223, 6,367,742
B1, 6,533,224, and others.
To Next Page
Loading...
