3. Press the SWITCH Key. The display shows the last switch used by
the DCS50 and its commanded position.
4. Use the NUMERIC KEYPAD to enter the number of the Option
Switch you want to change.
5. Press the c or t key to set the OpSw to the setting desired.
6. Press EXIT when finished. The DCS50 display will show -cS- to
indicate that you are running in command station mode or -br- to
indicate that you are running as a booster/throttle only.
The table below shows the effects of setting various option switches. The
factory settings for all DCS50 option switches is âtâ or thrown. If
you change option switches and experience unexpected results, just
set OpSw 39 to closed to reset the unit to the original factory set-
tings.
Do not change any option switches not listed in the table below.
49
To Next Page
